Filter
Top Products
Section 6Edition 3
Rev G
6-2
6. Upon selection of YES, the chart is initialized and the unit exits to the NORMAL DISPLAY if Chart Rotation
and Trend Data Collect are ON. If either Chart Rotation or Trend Data Collect are OFF, after the initialization
message, the unit will display CHART ROTATION OFF and/or TREND DATA COLLECT OFF, as applicable, until
any key is pressed. This is a reminder that normal recording will not commence.
6.2 CHART CONFIGURATION
To enter Chart configuration, from the Normal Display, press the until SELECT appears in the upper
display line and CHART CONFIGURATION appears in the lower display line. If CHART KEY DISABLED ap-
pears in the lower display line, refer to Section 9, Enables and Passwords, for instructions to enable Chart
Prompts. If PASSWORD appears in the lower display line, the correct "password" will need to be entered before
access to the Chart Select is allowed.
1. Press the to display CHART SIZE.
2. Press the to advance to the next parameter, CHART TYPE USED.
Press the to change, then to
desired choice, then press the .
CHART TYPE USED
RINGS ONLY
Selection
RINGS/LINES/SCALES
RINGS AND TIMELINES
RINGS ONLY
Press the to change, then to
desired choice, then press the .
CHART SIZE
12in
Selection
10in 11in 12in
Note: When changing
chart size, calibration of
the instrument to the
chart is required. See
chart calibration in
Section 11.