Filter
Top Products
Section 4Edition 3
Rev G
4-32
4.1.5 PROCESS VARIABLES
Process Variables define variables for use with alarms and/or control outputs
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until PROCESS VARIABLES appears in
the lower display line.
1. Press the to display PROCESS VALUE NUMBER.
2. Press the to advance to the next parameter, COPY/INITIALIZE.
Select YES if the parameters to be programmed are the same as another PROCESS VARIABLE already pro-
grammed.
Press the to change, then to
desired number, then press the .
Press the to change, then to
desired choice, then press the .
PVx COPY / INITIALIZE
NO
Selections
NO or YES
P
R
O
C
E
S
S
V
A
R
I
A
B
L
E
S
PROCESS VALUE NUMBER
1
Selections
1 to 4