Filter
Top Products
44
Recording/Playing Back a Song
When using CHO/DLY
Select from “CHORUS,” “DELAY,” or “DBLN” (doubling).
fig.00-438d
When using REV
Select from “HALL” or “ROOM.”
fig.00-439d
4. If you want to change the settings for the selected
effect, press CURSOR [ ] [ ] to select the parameter,
then change the setting’s value with the TIME/VALUE
dial.
fig.00-440d
For more on the settings content, refer to “Loop Effect
Parameter Functions” (p. 111).
5. Press CURSOR [ ] [ ] to display the Send Level
settings screen.
When using CHO/DLY
fig.00-441d
When using REV
fig.00-442d
6. Press CURSOR [ ] [ ] and the TIME/VALUE dial to
adjust each track’s send level.
* Pressing a REC TRACK button moves the cursor to the track
corresponding to the button pressed.
The “send level” is the volume level of the signal sent
from each respective track to each effect, and you can
change the amount of effect applied by adjusting the
send level.
The send level for each track is also indicated in the
lower row of the display.
fig.00-443d
7. After you have completed adjusting the send level,
press [EXIT] repeatedly to return to the Play screen
You can switch screens in the following sequence, with the
screen cycling to the next screen each time [LOOP EFFECTS]
is pressed.
Loop Effects selection screen → Send Level screen →
Type screen → Play screen
Send level of the each tracks