Filter
Top Products
107
Chapter 8 Parameters Guide
Chapter
8
You can control the wah effect in real time by adjusting the
EXP Pedal or the expression pedal connected to the EXP
PEDAL 2 jack.
This is an effect that produces a long sustain by evening out
the volume level of the input signal. You can also use it as a
limiter to suppress only the sound peaks and prevent
distortion.
SUB WAH
Parameter/
Range
Explanation
Type
Selects the type of wah.
CRY WAH
This models the sound of the CRY BABY wah
pedal popular in the ‘70s.
VO WAH This models the sound of the VOX V846.
Fat WAH This is a wah sound featuring a bold tone.
Light WAH
This wah has a refined sound with no unusual
characteristics.
Bass WAH
This wah has been specially adapted for use in
the bass registers.
Inclusion of the low-frequency range in the
wah sound produces a robust wah effect, with
no dilution of the sound.
Reso WAH
This completely original effect offers enhance-
ments on the characteristic resonances pro-
duced by analog synth filters.
Pedal Pos (Pedal Position)
0–100
Adjusts the position of the wah pedal.
This parameter is used after it’s been assigned to an
EXP Pedal or similar controller.
Pedal Min (Pedal Minimum)
0–100
Selects the tone produced when the heel of the
EXP Pedal is depressed.
Pedal Max (Pedal Maximum)
0–100
Selects the tone produced when the toe of the
EXP Pedal is depressed.
EffectLev (Effect Level)
0–100
Adjusts the volume of the effect sound.
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
SUB COMP (Sub Compressor)
Parameter/
Range
Explanation
Type
Selects the compressor type.
BOSS Comp This models a BOSS CS-3.
Hi-BAND
This is a compressor that adds an even stronger
effect in the high end.
Light This is a compressor with a light effect.
D-Comp This models a MXR DynaComp.
ORANGE
This is modeled on the sound of the Dan Arm-
strong ORANGE SQUEEZER.
Fat
When applied heavily, this compressor effect
provides a fat tone with a boosted midrange.
Mild
When applied heavily, this compressor effect
produces a sweet tone with the high end cut.
Stereo Comp This selects a stereo compressor.
Sustain
0–100
Adjusts the range (time) over which low-level
signals are boosted. Larger values will result in
longer sustain.
Attack
0–100 Adjusts the attack time.
Tone
-50–+50 Adjusts the tone.
Level
0–100 Adjusts the volume.
GT-10B_e.book 107 ページ ２００８年２月２６日 火曜日 午後３時３０分