Filter
Top Products
38
Chapter 2 Creating Sounds (Patch Edit)
4.
Select an effect you want to move.
Pressing the effect button for the effect you want to move lets you choose the
effect.
• Pressing [CATEGORY/ENTER] or the
EFFECTS SELECT button for the currently
selected effect switches the effect on or off.
• There are two effect routes—channel A (upper)
and channel B (lower)—and [CHANNEL
SELECT] is used to select which one to use.
5.
Move an effect to the point where you want to have an effect inserted.
and cannot be moved.
6.
If you want to change the sequence further, repeat Steps 4 and 5.
• If you want to name the patch or edit the name,
proceed to “Naming a Patch (PATCH NAME)”
(p. 42) before you save.
• If you want to save a name of the patch with
the settings you’ve made, proceed to “Saving a
Patch (PATCH WRITE)” (p. 43).
Compressor/
Limiter
Delay Foot Volume
OD/DS Chorus Send/Return
PREAMP Reverb
Digital/USB
Out
EQ Pedal FX INPUT jack
FX-1
Noise
Suppressor1
OUTPUT jack
FX-2
Noise
Suppressor2
Checking the Effect Level with the Level Meter
In the upper right of the FX CHAIN screen, you can meter the output level of each effect.
To check an effect’s output level, move the cursor to the desired effect.
You can check the level of signals being input to the INPUT jack by selecting .
Selecting allows you to check the level of signals output from the GT-10B.
GT-10B_e.book 38 ページ ２００８年２月２６日 火曜日 午後３時３０分