Filter
Top Products
25
Chapter 1 Outputting Sounds
Chapter
1
The GT-10B has a variety of Play screen variations. You can switch the information shown in the Play screen by pressing .
• You can use the PARAMETER knobs 1 through 4 to work with the values of the parameters displayed at the bottom of the Play screen. Also, for each parameter,
you can change the corresponding assignment at the SYS KNOB ASSIGN screen (p. 47).
• The parameter name displayed at the each Play screen is abbreviated. For details about parameter names, refer to “Parameters You Can Set with PDL:CTL/EXP”
(p. 125) or “Display of Parameters You Can Set with SYS KNOB SETTING” (p. 138).
Switching the Play Screen
Screen 1
This displays the name of the patch and the
parameters you can work with using the
PARAMETER 1 through 4 controls.
Screen 2
This screen displays the effect channel level
and the preamp that’s in use.
Screen 3
This screen displays the effect channel
mode and the effect channel level.
Screen 4
This screen displays the functions assigned
to CTL 1 and 2, the EXP PEDAL SW, and the
EXP Pedal.
Screen 5
This screen displays the functions assigned to
the Number Pedal Switch, CTL 3 and 4, the
external expression pedal (EXP PEDAL2).
Screen 6
This is the screen shown when you’re in
Manual mode (p. 56). Manual mode is en-
abled only while this screen is displayed.
Pressing [CATEGORY/ENTER] in this
screen allows you to make settings for
MANUAL MODE SETTING.
Screen 7
The effects used, as well as their connection
sequence (CHAIN) in a channel is indicated.
Screen 8
The patch name and the output level meter
are displayed.
Adjusting the Output Level
1.
Adjust the GT-10B’s output level with the OUTPUT LEVEL knob.
* About the S icon and A icon displayed at the Screen 4 and 5.
The S icon displays when the Pedal Function is enabled (p. 48).
The A icon displays when the Patch Assign Function is enabled (p. 51).
GT-10B_e.book 25 ページ ２００８年２月２６日 火曜日 午後３時３０分