Filter
Top Products
113
Chapter 8 Parameters Guide
Chapter
8
Creating Harmonist Scales (User Scale)
When HARM is set to any value from -2oct to +2oct, and the
harmony does not sound the way you intend, use a User scale.
You can set the corresponding pitches to be output for each
input pitch.
1.
Set HR1 (or HR2) to User in the HARMONIST screen.
2.
Select the screen of the HR1 settings (page 2) or the HR2
settings (page 3) with Cursor [ ].
The User scale setting screen appears.
3.
Use Cursor [ ] [ ], dial, to set the amount of pitch
shift for each voice.
You can have sound played on the bass be held continuously.
This effect allows you to perform the melody in the upper
registers while holding a note in the lower registers.
Because of the need to analyze the pitch, chords (two or more sounds played
simultaneously) cannot be played. Be sure to mute all the other strings and
play only one note at a time.
SOUND HOLD
Parameter/
Range
Explanation
Hold
Off, On
Switches the hold sound on and off.
Normally, this is controlled with the CTL 1, 2
pedals or CTL 3/4 jack or the footswitch con-
nected to the CTL 3,4 jack.
• It is assumed that this parameter will be assigned
(p. 126) to the footswitch.
• Patches are written with the Hold parameter set
to Off.
Rise Time
0–100
Adjusts how rapidly the Sound Hold sound is
produced.
EffectLev (Effect Level)
0–120
Adjusts the volume of the hold sound.
GT-10B_e.book 113 ページ ２００８年２月２６日 火曜日 午後３時３０分