Filter
Top Products
13
Names of Things and What They Do
1.
SUB OUTPUT Jacks L, R
These balanced output jacks use XLR type connectors.
2.
GND LIFT Switch
You can disconnect the SUB OUTPUT jacks’ No. 1 pin
from the GT-10B’s ground.
Switch this to LIFT if a ground loop or similar problem is
causing output of hum or noise. Normally, this is set to
GND.
3.
INPUT Jack
The bass is connected here.
4.
OUTPUT Jacks L/MONO, R
Connect to your amp, mixer, or such device.
5.
PHONES Jack
Connect headphones here.
Tonal adjustments for monitoring are applied when headphones are
connected to the PHONES jack.
6.
EXT LOOP SEND RETURN Jacks
Connect to external effects processor or amp.
7.
AMP CONTROL Jack
When using the AMP CONTROL function (p. 132),
connect to the jack used for switching bass amp
channels.
8.
EXP PEDAL 2/CTL 3, 4 Jack
Connect an optional expression pedal (such as the
Roland EV-5) or footswitch (such as the BOSS FS-6) here
(p. 22).
9.
USB Connector
Use a USB cable to connect a computer to this connector
and enable exchange of data between the GT-10B and the
computer (p. 94).
10.
DIGITAL OUT Jack
Outputs digital audio signals (p. 68).
11.
MIDI IN/OUT Connectors
Connect an external MIDI device to these connectors to
transmit and receive MIDI messages (p. 83).
12.
POWER Switch
Turns the power on and off.
13.
DC IN (AC Adaptor) Jack
Connect the included AC adaptor here.
* To prevent damaging the GT-10B, please be sure not to use
any AC adaptor other than the one included with the GT-10B.
14.
Cord Hook
Hook the AC adaptor cord here to prevent the adaptor
plug from being disconnected (p. 22).
* Disconnecting the AC adaptor while the GT-10B is in use may
result in corruption of important data.
15.
Security Slot ( )
Connect a commercially available anti-theft security
cable here.
http://www.kensington.com/
16.
Grounding Terminal
Connect the ground cable here.
Before using the grounding terminal, carefully read the sections entitled:
Notes in the “Making the Connections” (p. 23).
The GT-10B comes with the following items. After opening
the package, please check all items. If any items are missing,
please contact the retailer from whom this product was
purchased.
• GT-10B
• AC Adaptor (Roland PSB-1U)
• Owner’s Manual (This document)
• Roland Service (Information Sheet)
Rear Panel
3
7
9
10
11
12 13
2
5
6
8
4
14
15
16
1
Checking the Package Contents
GT-10B_e.book 13 ページ ２００８年２月２６日 火曜日 午後３時３０分