Filter
Top Products
49
Chapter 4 Playing Sounds
Chapter
4
This procedure sets the functions for the GT-10B’s controllers (CTL/EXP Pedal, EXP PEDAL SW) for individual patches.
* Set the Prefernc parameter of the CTL/EXP Pedal and EXP PEDAL SW (p. 137) settings to “Patch.”
Setting CTL/EXP Functions Individually in Each Patch (PEDAL FX)
1.
The MST/PDL FX screen appears.
2.
Select PEDAL/FX.
3.
The PDL:CTL/EXP screen appears.
Pressing [DISPLAY MODE] toggles the display between Knob View and
List View.
4.
Make the parameter settings.
P1: CTL1 Pedal
P2: CTL2 Pedal
P3: EXP PEDAL SW
P4: EXP Pedal
• Some EXP Pedal parameters use multiple pages for the parameter
settings. You can use [ ] or [ ] to switch pages.
• Each time [MASTER/PEDAL FX] is pressed, the EXP Pedal functions
alternate as shown below.
The currently selected setting is the one highlighted at the
lower right of the display.
For information on what settings you can assign, refer to “SW&PDL
FUNCTION” (p. 122).
5.
To save the settings, use the Write procedure (p. 43).
Example of Setting the Pedal Function
Setting the parameters as shown below in the EXP1 PEDAL SETTING screen enables you to constantly use the GT-10B’s
EXP Pedal as a wah pedal.
Prefernc: System
Function: WAH
Min: 0
Max: 100
Parameter Functions Switched
Foot Volume
Normal Foot Volume
(Does not include an ON/OFF
switching function)
Pedal Bend Pedal Bend On/Off
WAH Wah On/Off
PB/FV Pedal Bend, Foot Volume
WAH/FV Wah, Foot Volume
GT-10B_e.book 49 ページ ２００８年２月２６日 火曜日 午後３時３０分