Filter
Top Products
51
Chapter 4 Playing Sounds
Chapter
4
You can set the CTL/EXP Pedal, EXP PEDAL SW, and external controllers (footswitch and expression pedal) connected to the
rear panel’s EXP PEDAL 2/CTL 3,4 jacks for each individual patch.
You can save up to eight separate settings per patch (using Assign numbers 1 through 8) that determine what parameters are
controlled by which controllers.
* Set the Prefernc parameter of the CTL/EXP Pedal and EXP PEDAL SW (p. 137) settings to “Patch.”
Quick Settings
When you select prepared settings (Quick Settings), the relevant parameters are instantly set to their optimal values. This lets you
make the settings simply, instead of setting each individual parameter separately.
Setting Each Controller Functions to Individual Patches (Assign)
1.
The MST/PDL FX screen appears.
2.
Select ASSIGN.
3.
The ASSIGN screen appears.
4.
Select one of the ASSIGN number (No.1–8).
5.
Set the selected Assign number to “On.”
Each time [MASTER/PEDAL FX] is pressed it
alternately switches the selected ASSIGN number
on and off. When on, the Assign number at the
bottom left of the display and the “ON” indication
at the bottom right are highlighted. Be sure to set
any Assign settings not being used to “Off.”
6.
Select the Quick Setting (P**, U**).
Display
Explanation
Quick:U**
User Quick Settings
Quick:P** Preset Quick Settings
U01-1.1–U50-4.8 User Patch
When you select a User patch or Preset patch, you can use the existing patch’s assign
settings just as they are.
P01-1.1–P50-4.8 Preset Patch
7.
To use the Quick Settings with other Assigns, repeat Steps 4–8.
8.
To save the settings, use the Write procedure (p. 43).
GT-10B_e.book 51 ページ ２００８年２月２６日 火曜日 午後３時３０分