Filter
Top Products
116
Chapter 8 Parameters Guide
This consecutively interrupts the sound to create the
impression that a rhythm backing phrase is being played.
This effect creates vibrato by slightly modulating the pitch.
SLICER
Parameter/
Range
Explanation
Pattern
P1–P20
Select the slice pattern that will be used to
cut the sound.
Rate
0–100,
BPM –BPM
Adjust the rate at which the sound will be
cut.
When set to BPM, the value of each parameter will be set according
to the value of the “Master BPM” (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
If, due to the tempo, the time is longer than the range of allowable settings, it
is then synchronized to a period either 1/2 or 1/4 of that time.
Trig Sens (Trigger Sensitivity)
0–100
Adjusts the sensitivity of the sensor to play
the selected pattern from the beginning.
When strongly picked notes play the
rhythm of pattern will play from the begin-
ning.
With high settings of this parameter, the
pattern will be restarted from the begin-
ning even by softly picked notes.
VIBRATO
Parameter/
Range
Explanation
Rate
0–100,
BPM –BPM
Adjusts the rate of the vibrato.
When set to BPM, the value of each parameter will be set according
to the value of the “Master BPM” (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
If, due to the tempo, the time is longer than the range of allowable settings, it
is then synchronized to a period either 1/2 or 1/4 of that time.
Depth
0–100
Adjusts the depth of the vibrato.
Trigger
Off, On
This selects on/off of the vibrato.
It is assumed that this parameter will be
assigned (p. 51) to the footswitch.
Rise Time
0–100
This sets the time passing from the moment
the Trigger is turned on until the set vibrato
is obtained.
When a patch with Trigger set to On is called up,
the effect obtained is identical to what happens
when Trigger is switched from Off to On. If you
want the vibrato effect to be produced
immediately after the patches are switched, set
Rise Time to 0.
GT-10B_e.book 116 ページ ２００８年２月２６日 火曜日 午後３時３０分