Filter
Top Products
29
Chapter 1 Outputting Sounds
Chapter
1
Changing the Tuner Settings (Tuner Out)
1.
Turn on the Tuner.
2.
Move the cursor to OUTPUT.
3.
Select the output while Tuner is on.
• When OUTPUT is set to “Bypass,” and Tuner
is set to ON, you can adjust the volume of the
direct sound by operating the EXP Pedal.
• OUTPUT is set to “Bypass” when shipped
from the factory.
Value
Explanation
Bypass
Sounds input to the GT-10B bypass the processing
and are output directly as is.
Mute Sounds are muted, and no sound is output.
TUNER
Effector
FX
Off
On
TUNER
Switch
TUNER
OUTPUT
EXP
Pedal
Mute
Bypass
Switching the Tuner On and Off with the CTL Pedal
By setting the CTL Pedal function (p. 48) to “Tuner,” you can switch the tuner on and off with one of the CTL pedals.
Switching the Tuner On and Off by Lifting Up on the EXP Pedal
When the EXP Pedal is functioning as a Foot Volume control, set one of the ASSIGN 1–8 Assign Variable settings (p. 51) as
follows.
With these setting, you can switch on the Tuner by drawing back the EXP Pedal.
Switching the Tuner On and Off with the Number Pedal
Set the Num Pdl Sw function (p. 58) to Tuner to switch the tuner on and off with the number pedal of the current patch.
Target: Tuner Sw Src Mode: Moment
Min: On ActRngLo: 0
Max: Off ActRngHi: 1
Source: EXP1 PEDAL
GT-10B_e.book 29 ページ ２００８年２月２６日 火曜日 午後３時３０分