Filter
Top Products
55
Chapter 4 Playing Sounds
Chapter
4
The GT-10B features a function called Internal Pedal system. This function assigns specified parameters to a virtual expression
pedal (the internal pedal), providing an effect that automatically changes volume and tone in real time just the way an expression
pedal functions.
The Internal Pedal system features the following three functions, allowing you to set Source for each ASSIGN No.1-8 of the
“Manual Settings” (p. 52).
* When the Internal Pedal or the Wave Pedal is used, set the ASSIGN Src Mode to Moment.
Internal Pedal
With the trigger you have set, the assumed expression pedal starts working. If you have set INTERNAL PDL to Source, set the Int
Trig parameter.
For more detailed information on the parameters that can be set using Internal Pedal, refer to “Int Trig (Internal Pedal Trigger)” (p. 126), “Int Time (Internal Pedal
Time)” (p. 126), and “IntCurve (Internal Pedal Curve)” (p. 126).
Wave Pedal
This changes the parameter selected as a target in a certain cycle with the assumed expression pedal. When you have set Wave
Pedal for Source, the WaveRate and Waveform should be set.
For more detailed information on the parameters that can be set using Wave Pedal, refer to “WaveRate (Wave Pedal Rate)” (p. 126) and “Waveform (Wave Pedal
Form)” (p. 126).
Input Level
The parameter set as the target changes in response to the input level.
If you want to adjust the input sensitivity, set the “INPUT SENS” (p. 127).
Activating the Virtual Expression Pedal at the Start of Operations
(Internal Pedal System)
Example of Assign Settings
Setting the parameters as shown below enables you to use the GT-10B’s EXP Pedal as a UNI-V Rate parameter.
Target: FX1:UV:Rate Src Mode: Moment
Min: 0 ActRngLo: 0
Max: 100 ActRngHi: 127
Source: EXP1 PEDAL
GT-10B_e.book 55 ページ ２００８年２月２６日 火曜日 午後３時３０分