Filter
Top Products
111
Chapter 8 Parameters Guide
Chapter
8
This adds a note one octave lower, creating a richer sound.
Because of the need to analyze the pitch, chords (two or more sounds played
simultaneously) cannot be played.
This effect changes the pitch of the original sound (up or
down) within a range of two octaves.
*1 With Voice set to 2-Mono or 2-Stereo, you can select two sounds.
OCTAVE
Parameter/
Range
Explanation
Range
This selects the register to which the effect is applied.
Range 1
B0 (Low B) to E5 (corresponds to the 1st string
played at the 28th fret on six-string bass)
Range 2
B0 (Low B) to E4 (corresponds to the 1st string
played at the 21st fret on four- or five-string
bass)
Range 3
B0 (Low B) to E3 (corresponds to the 1st string
played at the 9th fret on four- or five-string
bass)
Range 4
B0 (Low B) to E6 (corresponds to the 1st string
played at the 24th fret on guitar)
Oct.Level (Octave Level)
0–100
Adjusts the volume of the sound one octave be-
low.
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
PITCH SHIFTER
Parameter/
Range
Explanation
Voice
Selects the number of voices for the pitch shift sound.
1-Voice
One-voice pitch-shifted sound output in
monaural.
2-Mono
Two-voice pitch-shifted sound (PS1, PS2)
output in monaural.
2-Stereo
Two-voice pitch-shifted sound (PS1, PS2)
output through left and right channels.
PS1/PS2 (Pitch Shift)
Mode *1
Selection for the pitch shifter mode.
Fast, Medium
,
Slow
The response is slower in the order of
FAST, MEDIUM and SLOW, but the mod-
ulation is lessened in the same order.
Mono
MONO is used for inputting single notes.
You may be unable to produce the intended
effect when playing chords (two or more notes
played simultaneously).
Pitch *1
-24–+24
Adjusts the amount of pitch shift (the
amount of interval) in semitone steps.
Fine *1
-50–+50
Make fine adjustments to the interval.
The amount of the change in the Fine 100 is
equivalent to that of the Pitch 1.
PreDly (Pre Delay) *1
0 ms–300 ms,
BPM –BPM
Adjusts the time from when the direct
sound is heard until the pitch shifted
sounds are inputted. Normally you can
leave this set at 0ms.
When set to BPM, the value of each parameter will be set according
to the value of the “Master BPM” (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
If, due to the tempo, the time is longer than the range of allowable settings, it
is then synchronized to a period either 1/2 or 1/4 of that time.
Fbk (Feedback)
0–100
Adjusts the feedback amount of the pitch
shift sound.
Level *1
0–100
Adjusts the volume of the pitch shifter
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
GT-10B_e.book 111 ページ ２００８年２月２６日 火曜日 午後３時３０分