Filter
Top Products
52
Chapter 4 Playing Sounds
Manual Settings
Here, you can individually determine which controller is to control which parameter.
1.
The MST/PDL FX screen appears.
2.
Select ASSIGN.
3.
The ASSIGN screen appears.
Only the TARGET and the SOURCE are shown in
Icon View. If you want to have all parameters
appear, switch to List View.
For information on the parameters, refer to
“ASSIGN 1–8” (p. 126).
4.
Select one of the ASSIGN number (No.1–8).
5.
Set the selected Assign number to “On.”
Each time [MASTER/PEDAL FX] is pressed it
alternately switches the selected ASSIGN number
on and off. When on, the Assign number at the
bottom left of the display and the “On” indication
at the bottom right are highlighted. Be sure to set
any Assign settings not being used to “Off.”
6.
Select the controller that you want to edit the parameter.
7.
Select the parameter you wish to control.
You can rapidly select the parameter you want by
using the P1 knob to navigate down from the
broad category.
8.
To set the other Assigns, repeat Steps 4–7.
9.
To save the settings, use the Write procedure (p. 43).
GT-10B_e.book 52 ページ ２００８年２月２６日 火曜日 午後３時３０分