Filter
Top Products
133
Chapter 8 Parameters Guide
Chapter
8
*1 This setting value is enabled when the Ch.Mode parameter is set
to Freq Divide.
*2 This setting value is enabled when the Ch.Mode parameter is set
to Dynamic Sw, Dynamic A, or Dynamic B.
CH.SELECT (Channel Select)
Ch.Mode (Channel Mode)
Selects how the two channels are to be used.
Single
Only the channel selected with [CHAN-
NEL SELECT] or Ch.Select is used.
Dual Mix
The output of Channels A and B is mixed.
Dual L/R
Channel A is output from the left and
Channel B is output from the right.
Freq Divide
The low-frequency range is assigned to
Channel A, and the high-frequency range
is assigned to Channel B.
Dynamic SW
Channels A and B are switched according
to the bass input volume level.
The GT-10B switches to Channel B when
the strings are picked with greater force.
This produces dynamic tonal changes in
response to the picking dynamics.
Dynamic A
Channel A’s volume level is controlled
according to the bass input volume level.
The volume in Channel B is fixed.
Dynamic B
Channel B’s volume level is controlled ac-
cording to the bass input volume level.
The volume in Channel A is fixed.
Ch.Select (Channel Select)
Ch.A, Ch.B
These switch between the A and B chan-
nels for the effect.
Ch.A Lev/Ch.B Lev (Channel A Level/Channel B
Level)
0–100
Adjusts the volume of the each channels.
Xover f (Crossover Frequency) *1
100Hz–4.00kHz
This sets the frequency dividing the low-
and high-frequency ranges.
A
B
A
B
A
B
L
R
A
B
Low-frequency
Range
High-frequency
Range
A
B
Detect
Input Level
Sens (Sensitivity) *2
0–100
When the Ch.Mode parameter is set to
Dynamic Sw, raising the value allows
switching of the channels even with
weaker picking.
When the Ch.Mode parameter is set to
Dynamic A (or Dynamic B), raising the
value enables volume level changes in
Channel A (or Channel B) even with
weaker picking.
Release *2
0–100
This adjust the rate of the response when
the input level drops.
GT-10B_e.book 133 ページ ２００８年２月２６日 火曜日 午後３時３０分