Filter
Top Products
97
Chapter 7 Using the GT-10B Connected to a Computer Via USB
Chapter
7
Switches the output of the GT-10B sound to the OUTPUT and PHONES jacks.
Setting the Direct Monitor
1.
The SYSTEM MENU screen appears.
2.
Select USB.
3.
The USB screen appears.
4.
Move the cursor to Dir.Monitor.
5.
Select the Monitor mode.
For more information on signal paths set by the
Direct Monitor parameter settings, refer to “Signal
Flow” (p. 142).
Parameter/
Range
Explanation
Off
Set this to Off if transmitting audio data internally
through a computer (Thru).
No sound is heard at this time unless the setting for
the computer is Thru.
On
The GT-10B sound is output. Set this to On when us-
ing the GT-10B as a standalone device, without con-
necting to a computer.
(When the Dir.Monitor parameter is set to Off, only
sounds from USB In are audible.)
• This setting cannot be saved. It is set to On when the power is turned on.
• If you are using the special driver, you can control Dir.Monitor On/Off
from ASIO 2.0-compatible application.
SYSTEM
Audio signal
GT-10B sound
Headphones
Bass Amp
Dir.Monitor
USB OUT USB IN
Audio OUT
Audio IN
OUTPUT L/R
PHONES
Computer
GT-10B_e.book 97 ページ ２００８年２月２６日 火曜日 午後３時３０分