Filter
Top Products
16
Introducing the R-4 Pro
fig.panel-3.eps_50
XLR input connectors 1–4
These are analog audio input connectors compatible with mic preamps. They accept either balanced or
unbalanced connections.
You can use XLR input connectors 1–4 as four channels of monaural input or as two stereo pairs, 1/2 and
3/4. For details, refer to “1 Recording Setup” (p. 72).
* The XLR type connectors 1-4 can provide 48 V phantom power, allowing you to connect phantom-powered
condenser mics. In this case, turn on the phantom power switch ().
fig.XLR-TRS
922
This R-4 pro is equipped with balanced (XLR) type connectors. Wiring diagrams for
these jacks are shown below. Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
Line output jacks [LINE OUT]
These jacks output an analog audio signal. You can use RCA cables to connect powered speakers, audio
equipment, mixers, and other devices.
The regulated output level is fixed at -10 dBu.
* The volume for each channel during playback can be adjusted on the mixer screen (p. 19).
* Line output can be output as 4-indiv or monitor. See “5 System Setup” in System settings (p. 75) for details.
Side panel (right)
37
36
36
5
1:GND
2:HOT
3:COLD
37
R-4_e_new.book 16 ページ ２００６年１１月２０日 月曜日 午後１時９分