Filter
Top Products
32
Recording
● Record button [REC]
If you want to begin recording immediately, press the [REC] button.
● Other settings
If you want to monitor the sound being recorded, connect headphones to the PHONES jack and use the
monitor level knob to adjust the volume.
Adjusting the monitor level knob does not affect the level of the sound actually being recorded.
To play back the recorded sound, refer to “Playing back” (p. 37).
Recording standby
If you want to put the R-4 Pro in recording standby
mode to be ready to record, hold down the [PAUSE]
button and press the [REC] button.
The R-4 Pro enters recording standby mode. During recording
standby, the [REC] button blinks and the display alternates
between REC and STANDBY.
When recording is paused, the [REC] button blinks. In
addition, the display alternates between REC and PAUSE.
Press the [REC] or [PAUSE] button during recording standby or
while paused to start recording.
Recording-standby
Caution regarding placement and handling while recording
The internal hard disk is a precision device. If you subject the hard disk to physical shock, such as the
following, you may not be able to access the data on the disk, causing recording or playback to be
unsuccessful. In the worst case, irreparable damage may occur.
Please avoid subjecting the R-4 Pro to strong impact or continuous vibration during use.
The following actions may cause malfunctions
• Subjecting the unit to impact, such as dropping it from a table onto a hard floor.
• Subjecting the unit to continuous vibration, such as by leaving it on an uncushioned surface like
the floor of a moving automobile.
R-4_e_new.book 32 ページ ２００６年１１月２０日 月曜日 午後１時９分