Filter
Top Products
55
Editing
This command appends another project (of the same format) onto the end of the currently selected project.
The two files are joined to create a single new file.
You cannot perform playback, stop, or operate the scrub dial or shuttle dial while using this command.
1
Select the project (the “base project”) to which you want to append another
project.
In the Main screen, use the [NEXT] button or [PREV] button to select the desired project. Alternatively,
you can use the cursor buttons in the Finder screen.
fig.wave3-1.eps
2
Press the R-4 Pro [WAVE EDIT] button. The display
shows the Wave Edit Menu screen.
3
Use the [CURSOR] buttons to select 3 Combine, and
press the [ENTER] button.
fig.wave3-2.eps
The display shows an editing screen like the one at right.
* If you decide to cancel the operation, press the [EXIT] button.
fig.wave3-3.eps
4
Use the [CURSOR] buttons to select the project that you
want to append, and press the [ENTER] button.
fig.wave3-4.eps
If you decide to cancel the operation, press the [EXIT] button.
Even when the screen shown at the right is displayed, you can
cancel the process by pressing the [EXIT] button.
* Do not turn off the power while a project is being saved or while a
process is running.
* It may take some time to save the project if it contains a large amount
of data.
Combine
Base project
Project
to append
The “base project” and the “project to be appended” must have the same sampling frequency,
sample size (bit depth), and number of channels.
fig.wave3-error.eps
If you select a project that cannot be appended, a “Improper Proj.“
message is shown.
R-4_e_new.book 55 ページ ２００６年１１月２０日 月曜日 午後１時９分