Filter
Top Products
83
Appendix
The following describes how to close the connection between your computer and the R-4 Pro. You must use
the procedure described below to close the connection before you disconnect the USB cable.
Do not disconnect the USB cable or power down the R-4 Pro while it is connected to your
computer.
Windows
1
Close all software and windows (such as Explorer) that are referencing the R-4 Pro’s hard disk.
* If any software or windows (such as Explorer) that are referencing the R-4 Pro’s hard disk are open when you close
the USB connection between your computer and the R-4 Pro, an error will occur and the connection will not be
closed correctly.
2
In the Windows task tray, double-click the Safely Remove Hardware icon ().
The Safely Remove Hardware dialog box will appear.
3
Select the item that indicates the R-4 Pro.
Item indicating the R-4 Pro
4
In the dialog box, click [Stop].
5
When the Stop a Hardware Device dialog box appears, select the item that indicates the R-4 Pro,
and click
[OK].
6
When your computer indicates “Safe To Remove
Hardware,”
you can disconnect the USB cable between the
R-4 Pro and your computer.
When you disconnect the cable, the screen shown at right will
appear.
* Never switch off the R-4 Pro’s power or disconnect the USB cable before you have closed the connection. Doing so
may damage the internal hard disk.
Macintosh
1
Cancel the connection with the R-4 Pro displayed on the desktop.
If you’re using Mac OS X, drag the R-4Pro icon to the icon on the dock.
Normally, when you drag to the trash can located at the right edge of the dock, the indication changes from
the trash can to allowing you to cancel the connection.
If you’re using Mac OS 9, drag the R-4Pro icon to the trash.
2
When the icon has disappeared from the desktop, you can disconnect the
USB cable between the R-4 Pro and your computer.
Disconnecting the R-4 Pro from a computer
Windows XP, 2000 USB Mass Storage Device
Windows Me USB Disk
R-4_e_new.book 83 ページ ２００６年１１月２０日 月曜日 午後１時９分