Filter
Top Products
52
Editing
fig.wave-4.eps
4
In the same way, move to the end (point ) of the region
you want to extract, and press the [ENTER] button.
* The value of point is displayed as a location in the sample (data).
fig.wave-trim2.eps
fig.wave-5.eps
5
A screen asking you to confirm the specified points is
shown.
fig.wave-6.eps
If you are satisfied with the points you specified, press the
[ENTER] button to confirm the settings. If you decide to try again,
you can press the [EXIT] button once and re-specify the end of the
region (point ). You can then press the [EXIT] button once
again and re-specify the beginning of the region (point ).
Even when the screen shown at the right is displayed, you can
cancel the process by pressing the [EXIT] button.
* Do not turn off the power while a project is being saved or while a
process is running.
fig.wave-trim2.eps
6
The extracted region is saved as a
new project with the same name as
the original project but with
“-1”
appended to it. The original project
remains unchanged.
For example, if the original project is
named Project, the new project is named
Project-1.
2
2
2
1
2
Project
2
1
Project
Project Project-1
1
2
1
2
fig.media-full.eps
If the internal hard disk does not have enough space to save the project, a
“Media Full!” message is shown.
R-4_e_new.book 52 ページ ２００６年１１月２０日 月曜日 午後１時９分