Filter
Top Products
90
Application guide
These basic settings are used for recording birdsongs or similar outdoor sounds. Since batteries are required
for outdoor use, these settings take power conservation into account.
Panel settings
Recording Setup
LCD Setup
System Setup
Recording birdsongs outdoors
Phantom power switch ON if using a condenser mic that requires phantom power; otherwise OFF
Input Select Analog By lowering the sampling frequency (Rec Freq.) and
limiting the number of tracks, you can minimize the
size of the file to be written. These settings also re-
duce the number of time the hard disk is accessed,
thereby conserving power.
Rec Freq. 44.1 kHz
Rec Bit 16 bit
Rec Mode
STEREOx1,
MONOx1
Set to match the mics that are connected.
Pre Recording 4 Sec
The pre-recording setting lets you press the record
button when you hear birdsong; sounds that oc-
curred several seconds earlier is captured retroactive-
ly. When recording birdsong, four seconds is
sufficient. In comparison to allowing recording to
continue, this method minimizes the number of ac-
cesses to the internal hard disk.
However, with any pre-recording setting other than
OFF, recording always continues internally.
Project Name Date
Using the Date setting will make it easy to tell the
date and time that the recording was made.
BackLight Timer 5 sec
Battery Type Set to the type of batteries you’ve installed
R-4_e_new.book 90 ページ ２００６年１１月２０日 月曜日 午後１時９分