Filter
Top Products
85
Appendix
fig.time-code-2.eps
3
Use the [CURSOR] button to select 1 Setup, and press
the [ENTER] button.
The Timecode Setup screen is shown.
fig.time-code-3.eps
4
Use the [SCRUB/VALUE] dial to select Mode.
The modes are as shown below.(
The values in boldface are the default values.)
5
Use the [CURSOR] button to select Frame Rate.
6
Use the [SCRUB/VALUE] dial to select the Frame Rate value.
Frame Rate:
24, 25, 29.97, 29.97D, 30, 30D
D is the drop-frame method; everything else is the non-drop frame method.
7
After setting the value, press the [EXIT] button twice.
The display returns to the System Menu screen.
8
Return to the Main screen by pressing the [EXIT] button again.
fig.time-code-display.eps
9
When Mode is set to INT, EXT, or REC-RUN, the date and
time on the Main screen changes to the timecode.
* Please set Pre Recording to OFF when recording using timecode. If
Pre Recording is set, then the timecode will not match.
*If the [PAUSE] button is pressed during recording, the timecode
will not match during playback. Please exercise caution.
OFF The timecode is not recorded.
INT The R-4 Pro timecode is used. The timecode operates normally.
EXT Uses the timecode sent from the connected device.
REC-RUN The R-4 Pro timecode is used. The timecode runs only during recording.
RTC The internal clock is used in place of the timecode.
R-4_e_new.book 85 ページ ２００６年１１月２０日 月曜日 午後１時９分