Filter
Top Products
76
System setup
fig.date-1a.eps
You can set the date and time.
If Project Name is set to Date, the time you specify here is
used to set the date in the project name.
This setting is also used for the date and time shown in the
Main screen.
6 Timecode
Menu item Parameter Value Function
Setup
Mode
OFF The timecode is not recorded.
INT
The R-4 Pro timecode is used. The timecode
operates normally.
EXT
Uses the timecode sent from the connected
device.
REC-RUN
The R-4 Pro timecode is used. The timecode
only runs during recording.
RTC
The internal clock is used in place of the time-
code.
Frame Rate 24, 25, 29.97, 29.97D, 30, 30D Selects the frame rate.
Out Select ON, OFF
Selects whether to output the timecode to the
timecode connector.
Chase ON, OFF
Plays the project in the R-4 Pro that matches
the timecode input from the timecode con-
nector.
Set Int TC
MANUAL
(H: M: S: F)
H : 00–23
M : 00–59
S : 00–59
F : 00–23/24/29
(According to the Frame Rate set-
ting)
Sets the start time for the timecode when
Mode is set to INT.
* CURRENT is the current timecode.
JAM EXT
(H: M: S: F)
H : 00–23
M : 00–59
S : 00–59
F : 00–23/24/29
(According to the Frame Rate set-
ting)
When Mode is set to EXT, the start time for
the timecode can be set to match the external
device
* CURRENT is the current timecode.
Set Rec-Run
TC
TARGET
H : 00–23
M : 00–59
S : 00–59
F : 00–23/24/29
(According to the Frame Rate set-
ting)
When Mode is set to REC-RUN, the start time
for the timecode can be set.
7 Date & Time
Year Month
Date (Weekday)
Time
R-4_e_new.book 76 ページ ２００６年１１月２０日 月曜日 午後１時９分