Filter
Top Products
86
Appendix
Setting the internal timecode start time
fig.recording-1.eps
1
Press the [SYSTEM] button on the R-4 Pro.
The display shows the System Menu screen.
fig.time-code-1.eps
2
Use the [CURSOR] button to select 6 Timecode, and press
the
[ENTER] button.
The Timecode screen is shown.
fig.time-code-2.eps
3
Use the [CURSOR] button to select 2 Set Int TC, and
press the [ENTER] button.
The display shows the Set Int TC screen.
fig.time-code-set-int.eps
4
Use the [CURSOR] button to select the input location,
and then set the start time with the [SCRUB/VALUE]
dial.
* H:M:S:F: indicates Hours: Minutes: Seconds: Frames, respectively.
The F value differs according to the Frame Rate value in the Timecode
Setup.
* To cancel the settings, press the [EXIT] button.
fig.time-code-4.eps
5
Press the [ENTER] button.
After the screen shown in the figure to the right is displayed, the
set time is shown as CURRENT, and the timecode begins.
6
After setting the value, press the [EXIT] button.
The display returns to the Timecode screen.
7
Return to the Main screen by pressing the [EXIT] button again.
Setting the start time
R-4_e_new.book 86 ページ ２００６年１１月２０日 月曜日 午後１時９分