Filter
Top Products
9
Introducing the R-4 Pro
fig.panel-1.eps_50
Internal mics [MIC-L, MIC-R]
These are stereo mics built into the R-4 Pro. The audio entering MIC-L is recorded on the 1L channel, while
audio picked up by MIC-R is recorded on the 1R channel. If you’re recording via the internal mics, set the
System Settings menu item Recording Setup to Int-Mic. For details, refer to “Recording from the
internal mics” (p. 33).
* Don’t connect anything to input jacks you’re not using.
Internal speakers
These are built-in speakers for monitoring. If you want sound to be heard from the internal speakers, set
the System Settings menu item Speaker to ON. For details, refer to “Playing back” (p. 37).
* No sound will be heard from the internal speakers if you’ve connected headphones to the Headphone jack
( ). Nor will sound be heard from the internal speakers while recording or in recording-standby mode; this
prevents acoustic feedback from occurring.R-4 Pro
Power switch [POWER]
This turns the power on/off. To turn the power on or off, press and hold the power switch for about five
seconds. The power switch is lit blue when the power is on.
Don’t turn the power off during recording or playback. Before you turn off the power, you must make sure
that recording or playback is stopped.
* If you accidentally turn off the power during recording, the data that was being recorded will not be stored on the
hard disk.
* The hard disk may be damaged if you turn off the power of the R-4 Pro while data is being read from or written to
the hard disk (such as during recording or playback). You must also be careful not to turn off the power while data
is being transferred between the hard disk and an external memory device.
* Never turn off the power while the R-4 Pro’s display indicates Now Connecting... or Now Processing! Doing so
will cause the R-4 Pro to become unstable and may damage the internal hard disk.
* During recording, pressing the power switch will not turn off the power.
* The hard disk may be damaged if you turn off the power of the R-4 Pro while data on the hard disk is being written
or read, such as during playback or waveform editing.
The R-4 Pro’s controls and connectors
Top panel
1
2
3 4 5 6
7 8 9
10
2
1
13
11
12
14 15
16
17
1
2
34
3
R-4_e_new.book 9 ページ ２００６年１１月２０日 月曜日 午後１時９分