Filter
Top Products
60
Effects settings
You can adjust the R-4 Pro effects not only while standing-by for recording or playback, but also while you
listen to the sound during actual playback or recording.
This section explains how to adjust the effect settings while playing back or in recording standby mode.
fig.effect-set.eps
fig.effect-1.eps
1
Press the R-4 Pro [EFFECTS] button.
The Effects setup screen is shown in the display.
fig.effect-type.eps
2
Use the [SCRUB/VALUE] dial to select the desired effect
type.
For details on each effect type, see to “Effects” (p. 62).
fig.effect-link.eps
3
Press the [CURSOR] down button. The cursor will
move to the “Link” field.
Applying effects
CH1 CH2 CH3 CH4
The effect on/off setting and effect parameters are set independently for each
channel.
CH1+2 CH3+4
The effect on/off setting and effect parameters are linked for channels 1 and
2 and for channels 3 and 4.
Choose this setting if the project uses channels 1 and 2 and channels 3 and 4
as stereo pairs.
CH1+2+3+4 The effect on/off setting and effect parameters are linked for all channels.
3
6
2
1
R-4_e_new.book 60 ページ ２００６年１１月２０日 月曜日 午後１時９分