Filter
Top Products
105
Save/Load of Song data
<About save error>
If an error occurs for some reason during the save
operation, the error message as below appears.
If it appears, press the [EXIT/NO] key.
The display returns to the previous screen before
performing the save operation.
Note that saved data before the error message ap-
pears is all invalid.
<Note for saving data to more than one disc>
If you save data to more than one disc, we rec-
ommend to put a number on each disc in the
saving order (such as DISC-1, DISC-2, etc.) so
that you will easily know the order for inserting
discs when loading data.
<Hint 1>
In the description for saving data above, we assume
to use a non-recorded CD-RW/CD-R disc.
If you use a recorded disc (including a disc on which
computer data is recorded), also note the following.
By performing step 5 in the save operation proce-
dure shown above (“While “BkUp” is flashing, press
the [ENTER/YES] key”.) When a recorded disc is in-
serted, the display shows a warning message, fol-
lowed by the confirmation screen (where “Sure?”
flashes).
With this screen, you can choose whether erasing
the recorded data or ejecting the disc.
• To erase the existing (recorded) data
Press the [ENTER/YES] key while both “ERASE” and
“Sure?” are flashing.
The display shows the screen below and the VF80
starts erasing the disc.
As the erase process progresses, the number of
flashing “ * ” increases from left to right.
<Note>
You cannot abort the save operation before com-
pleted. Especially during the save operation to
more than one disc, if you happen to press the
[EXIT/NO]
key while removing or inserting a disc,
you have to redo the save operation from the
beginning with the first disc.
<Note>
If the message above appears while saving data
to a CD-R disc, you can no longer use the disc.
Press the [EXIT/NO] key (or the [STOP] key) to exit
the Setup mode.
When saving data to more than one disc, the first disc
will be ejected when it is full (i.e. there is no more
recording space on the disc), while “Insert Disk!” ap-
pears on the screen.
After inserting the second disc, the VF80 automati-
cally resumes the save operation.
After completing the save operation, the final disc is
ejected and the above screen appears. (See <Note> be-
low).
Flashing
Flashing
When completing the save operation, “Save Com-
pleted!” appears on the display (as shown below) and
the VF80 stops access to the drive, while the disc in
the CD-RW drive is automatically ejected.
While “B01” is shown, press the [ENTER/YES] key.
The VF80 starts the save operation.
The recorded space shown on the display is counted
down while the save operation progresses.
It will take some time for saving all data. The follow-
ing display example shows that the data of the se-
lected program number is being saved to the backup
number “B01”.
8
9
In the example above, the selected program data will
be saved to a CD-RW/CD-R disc with the backup num-
ber “B01”. The program title is copied to the backup
title (you can not edit it).
By rotating the [JOG] dial when the above screen is
shown, you can also select “Eject”, besides “B01”.
If you select “Eject” and then press the [ENTER/YES]
key, the disc will be ejected.