Filter
Top Products
116
Save/Load of Song data
To change the setting, press the [ENTER/YES] key when
the “CD-DA Setup” screen is shown.
The current setting starts flashing, showing it can be
edited. While flashing, use the [JOG] dial to select
“ON” or “OFF”, then press the [ENTER/YES] key to con-
firm.
Copy protection setting
You can restrict the disc copy (duplication) capa-
bility of an audio CD you are going to make.
While “CD-DA” is flashing, press the [ENTER/YES] key.
After showing “Please Wait!”, the display shows the
screen for selecting the program(s) to be record.
In the screen, a number such as “01” or “02” shows the
track number, while “NON” shows that no program is
assigned to the track.
Use the [JOG] dial to select a desired program and
press the [ENTER/YES] key.
The selected program is set to the first track.
After setting the copy protection, press the [EXIT/NO]
key.
The display returns to the screen for selecting the save
mode, in which “CD-DA” now flashes.
“ON” A disc you made can be copied to other digital
device once.
“OFF” A disc you made can be copied to other digital
device as many times as required (default).
<Note>
If the program time shows
“00: 00”
when selecting a pro-
gram as the screen example below, the
“Start”
and
“End”
points are not correctly set.
In other words, in the following conditions, the “Start”
and “End” points are not regarded as being correctly
set.
“Start point” = “End point”
“Start point” > “End point”
If you press the
[ENTER/YES]
key after selecting such a
program, the warning message as below appears on
the display and you cannot select the program.
“Void In!”, “Void Out!”, or “Void Data!”
<Note>
It is possible to select a program that is not inter-
nal mastering if it holds the correct
“Start”
and
“End”
points.
However, if you record such a program to a CD-
RW/CD-R disc with the audio CD format, only track
1 and 2 can be recorded.
So, make sure that you select programs properly
when making an audio CD.
• To record a single song to a CD-RW/CD-R disc,
select a program and press the [ENTER/YES] key,
and then go to step 10.
• To record more than one song to a CD-RW/CD-R
disc, repeat the procedure for selecting a program
described above (i.e. use the [JOG] dial to select a
program and press the [ENTER/YES] key) until
selecting all desired programs, and then go to step
10.
Press the [ENTER/YES] key again.
The display shows the screen in which the last pro-
gram number of the current drive flashes.
Its program title and recording time are also shown,
while the total time of songs is shown at the top of the
screen.
Data between the "Start point" and "End point" is trans-
ferred to an audio CD.
Before executing recording, we recommend you to con-
firm that the actual audio in the program starts just
after the "Start point" and ends just before "End point".
Flashing
Flashing
Flashing
Flashing
6
7
8
9