Filter
Top Products
107
Save/Load of Song data
Press the [SETUP] key to enter the setup mode.
The display shows the screen for selecting the setup
menu.
Use the [JOG] dial to select (highlight) “Load PGM”
and press the [ENTER/YES] key.
The display shows the screen for selecting a load de-
vice, where “IDE” is flashing.
Loading backup data from a CD-RW drive
<Note>
Do not carry out any VF80 key operation until
the access process to the CD-RW/CD-R disc is
completed.
<Note>
If you load song data which is saved to more
than one disc, set DISC-1 first.
If you set the other disc and go on the follow-
ing procedure, the VF80 automatically recog-
nized that the disc order i s not correct and
the display shows
“Wrong Disk”
, followed by
“Illegal No!”
momentarily, and the disc is au-
tomatically ejected.
After turning on both the VF80, insert the disc to the
CD-RW drive.
While the desired backup number/title is shown on
the display, press the [ENTER/YES] key.
The display shows the screen for creating a new pro-
gram on the current drive, to which data will be loaded
(“New PGM” lights).
When you load song data which is saved to more
than one disc, the display also shows the disc num-
ber currently set. The example below shows DISC-
1 is set.
By rotating the [JOG] dial, you can select a desired
program number/title from among available programs
in the VF80 current drive. You can also select “Eject”.
If you select “Eject” and press the [ENTER/YES] key,
the disc is ejected
Flashing
Flashing
Light up
The following procedure describes how to load FDMS-3 song data.
We assume that the optional CD-RW drive (Model CD-1A) is already installed to the VF80 and a CD-RW or CD-
R disc on which the song data is recorded is set.
While “IDE” is flashing, press the [ENTER/YES] key.
After briefly showing the model name of the connected
CD-RW drive, the display shows the screen for select-
ing a load mode, where “BkUp” (backup) is flashing.
To load song data saved, select “BkUp”.
To load a material from an audio CD, select “CD-DA”.
This procedure describes how to load song data, so
we select “BkUp” here.
See “Loading from an audio CD” described later for de-
tails about how to load a material from an audio CD.
Flashing
While “BkUp” is flashing, press the [ENTER/YES] key.
The display shows the backup number and title, as
well as recorded space.
Flashing
1
2
3
4
5
6