Filter
Top Products
65
Recorder Functions
7
8
6
• To set editing points by marks:
Press the [TIME BASE SEL] key.
Each data field for the Start, End and To points changes
to show the current option by mark as shown below.
Use the [CURSOR / ] keys to highlight the field for the
desired point, and press the [ENTER/YES] key.
The field starts flashing.
Use the [JOG] dial to select the desired mark and press
the [ENTER/YES] key.
The point is set to the selected mark.
<Note>
This operation can be performed only when any mark
is set. When no mark is set, "
00:ABS 0
" is the one and
only option for each point.
Use the [CURSOR ] key to highlight the field ("01"
above) for the number of times for repeat paste, and
press the [ENTER/YES] key.
"01" starts flashing and you can now enter the number
of times for repeat paste.
Use the [JOG] dial to select the desired number and
press the [ENTER/YES] key.
You can select any number between "01" and "99".
<Note>
Basically you can select the number of times for repeat
paste between 1 and 99, however, if the recordable space
of the hark disk is limited, you may not be able to select
the desired number. The VF80 automatically calculate
the available space and limit the number of times to the
appropriate value.
When setting the number of times for repeat paste to 02,
the copy & paste function is performed as below.
A''
A''
A
A'
A'
START Point
END Point
TO Point
Copy & paste within the same track.
Copy & paste between different track.
Press the [UNDO/REDO/F3] key while holding down the
[SHIFT] key.
The copy & paste (or move & paste) function is per-
formed. When finished, "Completed!" appears on the
screen.
<Hint>
You may use the [CURSOR >] to highlight "EXE" and press
the [ENTER/YES] key to perform the function, instead of
pressing the [UNDO/REDO/F3] key while holding down the
[SHIFT] key.
<Note>
The copy & paste (or move & paste) operation cannot be
performed when there is not enough disk space to per-
form the undo and redo operations. If you try to perform
the paste operation when there is not enough disk space,
The display will show "
Over Time!
", as well as the short
time.
In such a case, shorten the copy (or move) data by the
amount more than the displayed time or delete unnec-
essary sections or programs to keep the enough space,
and then try to paste again.
Undo/redo of Copy & Paste
You can undo a copy & paste or move & paste opera-
tion, as well as redo it (undo the undo operation).
• By pressing the [UNDO/REDO] key after completing the
copy & paste (or move & paste) operation, you can
return the track(s) to the condition before performing
the copy & paste (or move & paste) operation.
• By pressing the [UNDO/REDO] key just after
performing the undo operation, you can undo the undo
operation and return the track(s) to the condition
after performing the copy & paste (or move & paste)
operation.
Note the following for performing the undo/redo opera-
tion.
<Notes>
You can undo or redo only when the recorder is stopped.
If you carry out any of the following after performing the
copy & paste (or move & paste) operation, you cannot
undo/redo the copy & paste (or move & paste) opera-
tion.
1.Making a new recording
2.Performing a new editing
3.Letting the recorder run in playback (or recording)
mode and pass through the auto punch-in point while
the auto punch mode is active
4.Turning off the power of the VF80
5.Performing any of the program operations (select,
rename or delete).