Filter
Top Products
67
Recorder Functions
6
• To set editing points by marks:
Press the [TIME BASE SEL] key.
Each data field for the Start and End points changes to
show the current option by mark as shown below.
Use the [CURSOR / ] keys to highlight the field for the
desired point, and press the [ENTER/YES] key.
The field starts flashing.
Use the [JOG] dial to select the desired mark and press
the [ENTER/YES] key.
The editing point is set to the selected mark.
<Note>
This operation can be performed only when any mark
is set. When no mark is set, "
00:ABS 0
" is the one and
only option for each point.
Press the [UNDO/REDO/F3] key while holding down the
[SHIFT] key.
The erase function is performed. When finished, "Com-
pleted!" appears on the screen.
<Hint>
You may use the [CURSOR ] to highlight "EXE" and press
the [ENTER/YES] key to perform the function, instead of
pressing the [UNDO/REDO/F3] key while holding down the
[SHIFT] key.
• By pressing the [UNDO/REDO] key after completing
the erase operation, you can return the track(s) to the
condition before performing the erase operation.
• By pressing the [UNDO/REDO] key just after
performing the undo operation, you can undo the
undo operation and return the track(s) to the
condition after performing the erase operation.
Note the following for performing the undo/redo op-
eration.
<Notes>
You can undo or redo only when the recorder is stopped.
If you carry out any of the following after performing
the erase operation, you cannot undo/redo the erase
operation.
1.Making a new recording
2.Performing a new editing
3.Letting the recorder run in playback (or recording)
mode and pass through the auto punch-in point while
the auto punch mode is active
4.Turning off the power of the VF80
5.Performing any of the program operations (select,
rename or delete).
Undo/redo of Erase
You can undo an erase operation, as well as redo it
(undo the undo operation).