Filter
Top Products
66
Recorder Functions
4
5
3
1
2
Erasing track data
You can erase a desired part of track data. You can
select a track or tracks (of which you are going to erase
data) from among each individual track, each pair of
tracks, 1-6 and 1-8.
START Point
END Point
ABS 0
REC END
Erase
<Notes for the erase function>
• When all eight tracks (1 through 8) are recorded, if you
erase a part of the chosen track, only the erased part
becomes silent (no audio) and the following material
does not move advance to fill the gap.
Therefore, the REC END point remains the same.
However, if you erase a part between the chosen point
(=Start point) and the REC END point (=End point) of
all tracks, the REC END point moves advance.
• The erase operations are performed on the current
program. Therefore, do not change the current pro
gram until all the operations are completed.
Erasing
Set the Start and End points for the erase operation.
Using the digital scrub function, set the Start and End
points. See "Storing the digital scrub point" for details
about how to set the points.
While the recorder is stopped, press the [TRACK EDIT]
key.
The screen for selecting the track edit type appears.
Use the [JOG] dial to select "Erase" and then press the
[ENTER/YES] key.
The display shows the screen for selecting the track(s)
to be erased.
Use the [JOG] dial to select the track(s) to be erased.
Rotating the [JOG] dial changes the options among 1
through 8, 1&2, 3&4, 5&6, 7&8, 1-6, and 1-8.
The corresponding [TRACK STATUS/TRACK SEL] key(s)
of the selected track(s) light in red.
Press the [ENTER/YES] key after selecting the track(s).
The screen shows the Start and End points.
<Hint>
On the screen above, you can perform the following
operations.
1. Editing the Start and End points
2. Setting the Start point to "ABS 0" and the End point to "REC
END"
3. Checking the data to be erased
4. Setting the Start and End points by marks
• To edit the Start and End points:
Highlight the time field of a desired (Start or End) point, and
then press the [ENTER/YES] key.
The "seconds" value starts flashing, showing that you can
edit it. Use the [CURSOR / ] keys to move the flashing
value, and use the [JOG] dial to enter a value.
After entering the desired time, pressing the [ENTER/YES]
key to store the time data to the point.
• To set the Start point to "ABS 0" and the End point to
"REC END":
Press the [SETUP/F1] key while holding down the [SHIFT] key.
"ALL OFF" changes to "ALL ON", and the Start point is set
to "ABS 0", while the End point is set to "REC END" point.
This function is useful when you erase all track data.
• To check (monitor) the data to be erased [Source Play
function]:
Press the [TIME BASE SEL/F2] key while holding down the
[SHIFT] key.
The display shows the "Source Play" screen as shown
below and the recorder starts playback of the data to be
erased.
You can hear audio by moving up the corresponding
track fader. After checking audio, press the [STOP] key.
The display returns to the screen shown before perform-
ing the Source play function.