Filter
Top Products
129
SETUP mode
Setting the Record Protect function [“Rec Protect”]
The “Setting the Record Protect function” menu allows you to turn the Record Protection function On or Off.
When this function in turned “On”, you cannot record, paste, or erase data. Use this function to protect your
important data from being accidentally erased.
Select the desired slave type with the [JOG] dial and
press the [ENTER/YES] key.
It will be set to the selected slave type.
Select “Slave Type” in the menu selection display and
press the [ENTER/YES] key.
The currently set slave type will flash. “Vari” will be
flash in the initial setting.
Press the [EXIT/NO] key (or STOP key) to exit from
the SETUP mode.
Select “Rec Protect” in the menu selection display
and then press the [ENTER/YES] key.
The presently set item (On or Off) will flash.
“Off” will flash in the initial setting.
Select “On” or “Off” with the [JOG] dial and then press
the [ENTER/YES] key.
It will be set to the selected item (On or Off).
Selecting “Off” enables recording; you can record,
paste, and erase data.
Selecting “On” disables recording; and you cannot
record, paste, or erase data.
Press the [EXIT/NO] key (or STOP key) to exit from
the SETUP mode.
• Initial setting: [Off]
• Options: [On] or [Off]
* You can set the mode for each Program individually.
* The settings can be saved and loaded as part of the
song data.
* The settings are maintained after you turn off the
power to the VF80.
This is the mode whereby after chase
locking, it will free run by the internal
clock of VF80 or the digital in clock
from the external equipment should
the time drift away from that of the
master.
This is the mode whereby after chase
locking, it will constantly run by vari-
pitch so that the time does not drift
away from that of the master by
compensating the phase drift.
However, if digital in has been set, it
will operate the same as for “Free.”
This is the mode whereby after chase
locking, it will free run by the S/P DIF
clock only when there is S/P DIF digital
signals from the master.
However, if digital in has been set, that
clock will have priority.
<Note>
When recording is disabled (“On”) and you try to record,
paste, or erase data, the VF80 displays “Protected!” for a
second, indicating that you cannot perform the operation.
To perform the operation you need to enable recording
(“Off”).
flashing
flashing
Free
Vari
(Initial setting)
SPDIF
1
2
3
1
2
3