Filter
Top Products
53
Mixer Functions
1
2
3
4
1
2
3
2
3
5
Use the [JOG] dial to select the desired scene number
to be recalled.
Press the [SETUP/
F1] key while holding down the
[SHIFT] key.
The selected scene is recalled and the display changes
to the Normal display.
Deleting a scene
You can delete an unnecessary Scene or Temporary
memory by using the following procedure.
<Notes>
• You cannot delete the memory in scene number
00
.
If you select scene number
00
and try to delete the
memory, "
DELETE
" does not appear on the display.
• You cannot undo deleting a scene.
Be sure not to select a wrong scene number to be
deleted.
Press the [SCENE] key.
The display shows the scene number/title list.
Select a memory to be deleted using the [JOG] dial.
Press the [UNDO/REDO/
F3] key while holding down
the [SHIFT] key.
The message asking for confirmation to delete the scene
appears and "Sure?" flashes.
To cancel to delete the mark, press the [EXIT/NO] key
now.
Press the [ENTER/YES] key while holding down the
[RECORD] key.
The selected memory is deleted and the scene name
changes to "[Un-defined]", showing that no memory is
stored.
Press the [EXIT/NO] key.
The display returns to the Normal screen.
Fader adjust
After recalling a scene, the recalled fader level usu-
ally does not match the current physical fader posi-
tion, you can move the physical faders to match the
current fader positions of the scene.
The following description is assumed that "Fader re-
call setting" of the setup mode is set to "Trk & Mst."
Press the [SCENE/
FADER] key while holding down the
[SHIFT] key.
The display shows the fader setting screen.
The fader icon changes according to the relation be-
tween the physical fader position and recalled fader
position, as show below.
•The current physical fader po-
sition matches the recalled po-
sition.
•The current physical fader po-
sition is higher than the recalled
position.
•The current physical fader po-
sition is lower than the recalled
position.
Move a physical fader manually to match the recalled
(scene memory) position.
After adjusting all the fader positions, press the [EXIT/
NO] key.
<Note>
If you recall a scene when "
Fader recall setting
" of the
setup mode is set to "
OFF
", the current physical fader
positions are valid.
Flashing