Filter
Top Products
25
Basic Recording/Playback
DIGITAL MULTITRACKER
PHANTOM
ACCESS
PEAK
CH ON/OFF
LR
GUITAR
GUITAR
LINE MIC LINE MIC MIN MAX
MASTERING TRAINING
EFFECTEQPAN
SCENE SEQ.SCENE
TRACK
TRIMTRIM
MIX PARAMETER
PGM
FADER
MAP
ON/OFF
2TRK MODE
FOOT SW
ST OUT
PHONES
INPUT A
BOUNCE
INPUT B
PEAK
CH ON/OFF
UNBAL
UNBAL
BAL
BAL
F1
F2 F3
EDIT
REC EFF
OFF
ON
MIDI
OUTPUT INPUT OUTPUT
INPUT
POWER
PHANTOM
S/P DIF / DATA
Rear panel
Foot switch (mode 8051)
Amplifier + Speakers etc.
Microphones (Dynamic
or condenser type)
Headphones
Guitar processor
Electric bass
Electric guitar
Digital equipment (CD, MD, DAT etc.)
AC outlet
Sequencer
PC w/sequence software
Top panel
Connections of external equipment
You can connect various sound sources and external devices to the input and output connectors of the
VF80 as shown in the example below. When making connection, make sure that the [MASTER] fader
is set to the lowest (“∞”) position and the [PHONES] knob to the left most (“MIN”) position. Otherwise,
your speakers or headphones may damage by the audio noise generated when connecting cables.
<Note>
You cannot use both the
[BAL]
and
[UNBAL]
connectors on INPUT A and
INPUT B simultaneously. Plugging the
[UNBAL]
connector disconnects the
[BAL]
connector.
<Note>
Do not power on the machine with non-speci-
fied foot SW connected to the foot SW jack.
When powering on the machine with non-
specified foot SW (latch type foot SW, etc.)
connected to the foot SW jack, there is a case
that the machine does not correctly boot up
with “
No Drive!
” alert message. In such a case,
power off the machine once, disconnect the
foot SW and then power back on.