Filter
Top Products
85
Advanced Operations
<How to edit parameters>
The "L39: Gtr Dist" effect type has 11 parameters as
shown below. (Note that the screen example below
shows all parameters for the explanation. Actually,
you can see 5 parameters at a time while the other
parameters are hidden.)
Use the [CURSOR]
/ keys to select a highlighted
parameter. Use the [JOG] dial to select the value of
the highlighted parameter.
The monitor sound changes in realtime when chang-
ing a parameter.
1. Dist Type
Selects a distortion type.
Options: Acous, Rythm, OvDrv, Dist, Blues,
Fuzz, Lead, Metal (Default: Dist)
2. Dist Gain
3. Warm
Adjusts the distortion gain.
Range: 1 to 15 (The default depends on
the distortion type selected.)
4. Bass
Makes the sound warmer when On.
Options: ON, OFF (default: ON)
5. Middle
Adjusts the low frequency response.
Range: 0 to 10 (default: 5)
6. Treble
Adjusts the mid frequency response.
Range: 0 to 10 (default: 5)
7. Noise Gate
Adjusts the high frequency response.
Range: 0 to 10 (default: 5)
8. Out Level
Turns on or off the noise gate.
Options: OFF, 1 to 99 (default: OFF)
9. Delay Time
Sets the output level of the distortion.
Range: 0 to 99 (default: 80)
10. Feedback
Sets the delay time.
Range: 5 ms to 1200 ms (default: 250 ms)
11. Delay Level
Sets the feedback level of the distortion.
Range: 0 to 99 (default: 40)
Sets the delay level.
Range: 0 to 99 (default: 0)
<Storing parameter settings>
It will be a good idea to store a favorite pa-
rameter setting to a scene.
You can recall a stored setting whenever you
like. See page 52 for details about the scene
memory.
After making desired effect parameter settings in
rehearsal, record the guitar while monitoring the
effected sound.
Note that the dry sound is recorded though you
monitor the wet sound.
We assume that track 1 is "Input monitor" (i.e. the
[RECORD] key and the [TRACK STATUS/TRACK SEL]
key for track 1 are flashing).
Recording the guitar
Press the [EXIT/NO] key to switch to the Normal
screen.
Press the [PLAY] key while holding down the
[RECORD] key to start recording and play the
guitar.
The dry sound is recorded to track 1 while the wet
sound is monitored.
The screen shows both the recording level of the gui-
tar and the monitor level.
Press the [STOP] key to stop recording.
The [TRACK STATUS/TRACK SEL] key for track 1 still
flashes, while the [RECORD] key turns off.
Press the [REWIND] key while holding down the
[STOP] key to locate to the beginning of the pro-
gram.
<To playback the recorded sound>
To check the recorded "
dry
" sound just re-
corded, press the
[EFFECT]
key while holding
down the
[SHIFT]
key to turn off the effect,
then press
[PLAY]
key to start playback.
If you do not turn off the effect, the "
wet
"
playback sound is monitored with the effect
you set in rehearsal.
1
2
3
4