Filter
Top Products
97
Save/Load of Song data
REC END (07m 00s)
of real track
REC END (10m 00s)
of additional track
seven minutes
Additional
Tracks
Real Tracks
DAT
Save
<Items that can be saved or loaded as song data>
•Memory data:
AUTO PUNCH IN/OUT data and Start/End/To points,
Scene memories 00 through 99, Marks 00 through 99 (only can be saved/loaded using CD-RW drive)
•Timebase:
ABS, MTC or BAR/BEAT/CLK
•Setup mode:
Bar/beat setting, tempo setting, metronome on/off, preroll time, MIDI synchronization output signal
setting, MTC offset time, MTC offset mode, REC protect setting, slave mode on/off, and slave type setting
Fader fix mode setting, fader recall mode setting
<Items that cannot be saved or loaded as song data>
•On/off settings for auto play mode and auto return mode
•Vari pitch on/off and pitch data
•Setup mode:
DIGITAL IN and DIGITAL OUT settings, bar/beat resolution on/off setting, device ID setting and drive
select setting
<Notes for digital audio recorders to be used>
The VF80 song data only can be saved to or loaded from digital recorders that can handle 16 bit, 44.1 kHz
linear digital data with S/PDIF format (such as DAT recorders).
<Notes for saving data using the S/PDIF digital signal>
When saving all data including both real and Additional track data using the S/PDIF digital signal, note the
following.
Only the data recorded within the time duration between ABS 0 and REC END of the Real tracks is saved.
Therefore, if the recorded time of Additional tracks is longer than the Real tracks, only the Additional track data
within the time duration between ABS 0 and REC END of the Real tracks is saved.
In the example shown on the right, the Additional
tracks have data from "00m 00s" to "10m 00s", while
the Real tracks have data from "00m 00s" to "07m 00s".
If you are going to save all tracks, the Additional track
data from "00m 00s" to "07m 00s" will be saved but
the rest will not be saved.
In such a case, you can solve the problem by setting
the time length of saved data to 10 minutes by using
the "Save Length" screen mentioned later (see "step
4" on page 99). Note that the maximum save length
is 59 minutes 59 seconds.
The other way to solve the problem is to exchange
the Additional track data and the Real track data
before saving data. You should be careful not to lose
the Additional track data in this operation. See page
68 about the "track exchange operation".
Saving/loading data using the S/PDIF digital signal