Filter
Top Products
135
Appendix (Installing the optional CD-RW drive)
1
<Notes on installing the CD-RW drive>
• The CD-RW drive is made of precision parts.
Do not apply a mechanical shock or use excessive force when installing it.
• Before installing the drive, make sure that the power of the VF80 is off and the power cord is
disconnected.
• Install the drive correctly according to this manual.
Note that damage to the drive caused by inappropriate installation is not covered by the
guarantee.
How to install the CD-1A
Remove the side cover of the VF80 by unfastening
the two screws using a screw driver.
After removing the cover, remove the blank panel
attached inside the cover.
Retain the cover which will be used later.
2
Remove the metal fitting by unfastening the retain-
ing screw (indicated by an arrow) inside the CD-1A.
Because the screw head is small, use a micro screw
driver to carefully unfasten the screw without dam-
aging the head by excessive force.
3
Insert the CD-1A unit to the VF80 as shown below.
Carefully insert the CD-1A to the VF80 in the right
direction, without rubbing it against the VF80 cabi-
net. Push the unit carefully and firmly with your
both hands, but without excessive force, until you
feel the connector of the CD-1A mesh with the inter-
nal connector.
4
Using the screw (1 pc.) which tightened the blank
panel to VF80, fix CD-1A to the VF80 chassis.
Fasten the screws without excessive force.
Connect the power cable of the VF80 to an AC main
outlet, and turn on the power.
Check that the VF80 starts up and the indicator on
the front panel of the CD-1A flashes for a few sec-
onds and then turns off.
Do not operate the CD-1A unit the VF80 display
shows the Normal screen after showing the start-up
screen.
6
5
Fix the cover removed in step 1.
Cover
Blank panel
CD-1A
Connector
Insert the CD-1A