Filter
Top Products
Reference [Creating a CD]
ZOOM MRS-1266
134
(4) Current position in track
The location in the current track is shown here in hours (H),
minutes (M), seconds (S), and milliseconds (MS).
5.
Use the FF [
Y
] and REW [
T
] keys to select the
track to be played.
While the track number is shown, the FF [Y] and REW [T]
keys can be used to select the track on the CD. The FF [
Y]
key selects the next track and the REW [
T] key selects the
previous track.
6.
Use the cursor up/down keys to select the
playback method for the audio CD.
Each push of the cursor up/down keys toggles between the
following two methods.
●
D (Digital playback)
The digital audio signal of the CD is read by the MRS-1266
in the digital domain and becomes available as an audio
signal at the rear panel MASTER OUTPUT jacks, DIGITAL
OUTPUT connectors, and front panel MASTER PHONES
jack. (Default setting)
●
A (Analog playback)
The audio signal of the CD is reproduced via the headphone
outputs of the CD-R/RW drive.
7.
To start playback of the audio CD, press the PLAY
[
R
] key.
Playback of the selected track starts. When the track is
finished, playback continues with the next track. During
audio CD playback, all faders except for the [MASTER]
fader as well as the EQ, reverb, chorus/delay, and pan
settings are disabled.
8.
For track selection and for controlling playback
stop/pause, use the transport section keys.
PLAY [
R
] key
Playback of the selected track starts. Pressing the key during
playback sets the system to pause mode.
STOP [
P
] key
Playback stops, and the system returns to the beginning of
the current track.
FF [
Y
] key
Playback stops, and the system jumps to the beginning of the
next track.
REW [
T
] key
Playback stops, and the system jumps to the beginning of the
previous track.
9.
To return to the main screen, press the [EXIT] key
several times.