Filter
Top Products
Microwave Switch/Attenuator Driver 7
L4400 User’s Guide 155
Y1150A
The Y1150A supports the Agilent N181x series microwave switches shown
below. Up to eight switches in any combination can be connected to each
distribution board.
Y1150A Switch Options Supported
(Recommended options are shaded).
Agilent Switch Description
N1810UL Unterminated latching 3-port (SPDT)
N1810TL Terminated latching 3-port (SPDT)
N1811TL Terminated latching 4-port (transfer)
N1812UL Unterminated latching 5-port
Option Name Option Number Description and Comments
Frequency Range various All options supported
Coil Voltage 105 +5VDC
Highest coil current requirement of all coil voltage
options. May limit system speed because current
capacity limitations. This option draws 600 mA
(except N1810UL 300 mA). Therefore, a maximum of 3 (6)
devices may be switched simultaneously.
115 +15VDC
124 +24VDC (required if using internal power)
DC Connector
Type
201 D-Sub 9 pin female
202 Solder lugs
Can use ribbon cables with the Y1150A, or discrete wires
with the Y1155A.
RF Performance various All options supported
Drive Options 401 TTL/CMOS compatible
All switches on the same distribution board must use the
same drive mode.
402 Position indicators (required to use verification feature)
403 Current interrupts
For pulsed operation, current interrupts are not required.
May provide system switching speed improvements.