Filter
Top Products
5-5
MGP 464 • HTML Conguration and Control
PRELIMINARY
Scaler I/O Settings screen
On the Scaler I/O Settings screen (shown below), you can specify configuration
settings for the 4 fully congurable inputs, the 15 virtual inputs, and the output.
You can also select a test pattern and enable or disable blue mode.
Scaler I/O Settings screen
Conguring the inputs
The Input Configuration section of the Scaler I/O Settings screen lets you name,
enable and disable film mode for 3:2 and 2:2 pulldown, and select the video signal
type for each of the 19 available inputs.
Naming inputs
You can assign names to the inputs using the input name boxes located beneath
each input number. The name in this box is displayed on the screen as a text label
in the window, unless you specify otherwise. (See “Window Settings screen,” later
in this chapter.)
Initially, a default name is displayed in each box:
Input##
N
If you select a virtual input that actually consists of two inputs (S-video) or
three inputs (YUVi), only the first input number of the set is displayed in the
window.
For example, if inputs 5, 6, and 7 have been configured together as a YUVi
input, only 5 appears as the input number on the screen.