Konica Minolta CM-2600d Drums User Manual


 
E-104
TASK Mode
10
Place the specimen measuring port to the specimen according to the message dis-
played, make sure that is displayed, then press C (MEAS. button).
M
emo
If does not appear due to the auto power save function, this may be due the fact that it can take time
to start measurement after C is pressed.
11
<Performing the Next Measurement>
Turn B to select “NEXT” then press A.
The message for “JOB
*
” displayed
for the previous measurement will
appear.
<Performing the Same Measurement Again>
Turn B to select “REDO”, then press A.
The message “JOB
*
” that was dis-
played just before the measurement
was performed will appear.