Konica Minolta CM-2600d Drums User Manual


 
E-88
Assessments
4
Turn B to select “TOLERANCE”, then press A.
The currently set tolerances will be
displayed.
5
If they are satisfactory, turn B to select “BREAK”, then press A.
The measurement screen will ap-
pear.
6
Place the specimen measuring port to the specimen, and then press C (MEAS.
button).
The color difference, direction and amount of tint and brightness deviation from the target color will be dis-
played. In addition, on the right of “ E*” value, a pass/fail judgment result made based on the specified
elliptical tolerances will be displayed.
The color space to be used as the assessment axis differs depending on the selected color space.
When “L*C*h, E”, “L*C*h, CMC1:1”, “L*C*h, CMC2:1” or “L*C*h, CIE94” is selected:
Assessment will be made based on the direction of tint and lightness deviation and color difference
from the target color in the L*C*h axis. When a color space other than those given above is selected,
assessment will be made based on the direction of tint and lightness deviation and color difference
from the target color in the L*a*b* axis.
M
emo
Assessment results differ as shown in the table in page E-84 depending on the type of specified color difference
tolerances and pass/fail judgment result.