Filter
Top Products
E-63
Measurement
M
emo
• Measurement will no longer be possible once the total number of target color data and measured data reaches 1700
(700 in the “defined in COND.” mode). In this case, delete some target color data or measured data.
• The navigation wheel and MEAS. button cannot be used for three seconds after the MEAS. button is pressed, if
“UV100%” has been set for “UV SETTING”, or for four seconds if “UV0%” or “ADJUSTED” has been set.
• If the Ganz coefficient is re-downloaded and overwritten after measurement when “WI, Tint Ganz” has been se-
lected as the display mode, the measurement data will be replaced with the one that is calculated based on that
Ganz coefficient.
• If does not appear due to the auto power save function, this may be due the fact that it can take time to start
measurement after C is pressed.