Filter
Top Products
Trigger Mode [TRIGGER]
Reference
DTXTREME III Owner’s Manual
111
Drum Kit mode
Reference
Song modeClick modeTr igger modeFile modeUtility modeChain modeSampling mode
Other Settings [F5] OTHER
You can enter a name of up to 12 characters for the Trigger
setup currently being edited. For detailed instructions on
naming, refer to “Basic Operation” on page 15.
1 [SF6] LIST
When the cursor is located on the Name box, you can call up
the Character List by pressing the [SF6] LIST button and
enter the name. For detailed instructions on naming, refer to
“Basic Operation” on page
15.
From this display, you can copy a Trigger Setup (from a
specific Trigger Input jack of a specific Trigger Setup num-
ber) to the same or different Trigger Input jack of the same
or different Trigger Setup number. For example, if you
want to copy the Trigger Setup of the TOM1 jack to TOM4
within the current Trigger Setup, set the copy source to
”Current” and “tom1,” then set the copy destination to
”Current” and “tom5,” and execute the Copy operation.
The Copy operation can be executed by pressing the
[ENTER/STORE] button after making the parameter set-
tings.
1 Trigger Setup number as copy source
Determines the Trigger Setup number as copy source. “Cur-
rent” refers to the currently edited Trigger Setup.
B Trigger Input jack as copy source
Determines the Trigger Input jack as copy source.
C Trigger Setup number as copy destination
Determines the Trigger Setup number as copy destination.
“Current” refers to the currently edited Trigger Setup.
D Trigger Input jack as copy destination
Determines the Trigger Input jack as copy destination.
2. Adjust the “tom1” value of Reject Level From so that the
Crash1 sound is not triggered, even if hitting the pad connected
to the TOM1 jack.
The higher the value, the less likely the Crash1 sound will be
accidentally triggered.
3. After finding and setting the appropriate value, store the setting
as a User Trigger Setup and turn Input Lock off so that you can
play the drum performance.
NOTE
• If the “tom1” value of the Reject Level From is too large, the
Crash1 sound may not be triggered properly when you hit both the
Crash1 and Tom1 at the same time.
Naming the Trigger Setup
[SF1] NAME
Copying the Trigger Setup
[SF2] COPY
1
• When the Trigger Setup Copy operation is executed, the destination
Tr igger Setup will be replaced with the settings of the copy source.
• When setting the copy destination to “Current” and executing the Copy
operation, make sure to store the current Trigger Setup by pressing the
[ENTER/STORE] button on another display. This is necessary because
the edited Trigger Setup will be lost when selecting a different Trigger
Setup or when turning the power off; it also is necessary since the
Store operation cannot be performed from the [SF2] COPY display.
Settings Current, PRE: 01 – USR: 05
Settings snare – pad15
Settings Current, USR: 01 – USR: 05
Settings snare – pad15
CAUTION
CAUTION
42
31