Filter
Top Products
Saving the Created Data to a USB Storage Device
Quick Guide
56
DTXTREME III Owner’s Manual
Quick Guide
Loading a File Saved to a USB Storage Device
This section describes instructions on loading a file saved to a USB storage device as an “AllData” file.
1
Press the [FILE] button to enter the File mode.
2
Press the [F2] LOAD button to call up the Load display.
3
Move the cursor to the TYPE parameter, then set the File type to
“AllData” by using the data dial or the [INC/YES] and [DEC/NO]
buttons.
4
Press the Cursor [MM
MM
] button to move the cursor to the file/direc-
tory select box, then select the desired file to be loaded.
If the file is saved under any directory, select the directory including the desired file,
then press the [ENTER/STORE] button to find the desired file.
5
Press the [SF1] EXEC to execute the Load operation.
After the data has been loaded, a “Completed” message appears and operation returns
to the original display.
• Loading a file (extension: T3A) to the DTXTREME III automatically erases and replaces all
existing data in the User memory. Make sure to save any important data to a USB storage
device before performing any Load operations.
While the data is being loaded, make sure to follow these precautions:
•Never remove or eject the media from the device (USB storage).
•Never unplug or disconnect any of the devices.
•Never turn off the power of the DTXTREME III or the relevant devices.
CAUTION
CAUTION