Filter
Top Products
Setting Up
DTXTREME III Owner’s Manual
19
Connecting to Speakers or
Headphones
Since the DTXTREME III has no built-in speakers, you’ll
need an external audio system or a set of stereo headphones
to properly monitor it.
■ OUTPUT L/MONO, R jacks (standard
mono phone)
These jacks allow you to connect the DTXTREME III to an
external amplifier/speaker system and produce full, ampli-
fied sound.
• Use the DTXTREME III’s OUTPUT L/MONO jack
when connecting to a device with a mono input.
■ PHONES jack (standard stereo phone
jack)
The overall headphone level is adjusted by the PHONES
slider.
Connecting to External Audio
Equipment
When recording your performance on a DTXTREME III
Drum Kit or sending its sounds to a mixer, connect your
equipment as follows:
The OUTPUT (L/MONO and R) and INDIVIDUAL OUT-
PUT (1 to 6) jacks produce line level audio signals regard-
less of whether headphones are connected or not. These
jacks are mono phone type. To make audio connections via
these jacks, use cables with a mono phone plug for the
DTXTREME III and an appropriate plug for the other
device.
Use both OUTPUT jacks (L/MONO and R) for stereo out-
put. If the other device has a mono input, use the L/MONO
jack only.
The DIGITAL OUTPUT connector can be connected to a
coaxial digital input (S/P DIF) on an external audio device.
This connector digitally outputs stereo audio signals identi-
cal to those from the OUTPUT L/MONO and R jacks.
External audio signals input to AUX IN/SAMPLING IN
jack can be monitored together with the DTXTREME III
sounds via headphones connected to the PHONES jack,
and can be recorded to create additional User Voices. If
necessary, you can use the [GAIN] knob on the rear panel
to adjust the gain of the input signal.
• Whenever making connections, make sure that the plug on the cable
being used corresponds to the type of jack on the device.
• Do not use the DTXTREME III at a high volume level for a long period
of time, or your hearing may be damaged. Doing so may cause hearing
loss.