Filter
Top Products
Display Messages
Appendix
154
DTXTREME III Owner’s Manual
Please keep power on.
The data is being written to Flash ROM. Never attempt to turn off the power while data is being written
to Flash ROM. Turning the power off while this message is shown results in loss of all user data and
may cause the system to freeze (due to corruption of data in the Flash ROM). This may also result in
the DTXTREME III being unable to properly start up the next time the power is turned on.
Please stop sequencer. The operation you have attempted to execute cannot be done during Song playback.
Sample freq is too low. The sampling frequency is too low and the Frequency Convert Job cannot be executed.
Sample is protected. The sample cannot be overwritten because it is protected.
Sample is too long. The Sample size is too large and the Time Stretch Job cannot be executed.
Sample is too short. The Sample length is too short and the Frequency Convert Job cannot be executed.
Sample memory full.
The Sample memory is full and further Sampling operations, Jobs, or load operations cannot be exe-
cuted.
Seq data is not empty.
This message appears if you attempt to record to a track that already contains data. Clear the track
data in the Song Job mode or select a different track, then perform the Record operation.
Seq memory full.
The internal memory for Sequence data is full, preventing any further operation (such as recording,
Job execution, or loading from the USB storage device). Try again after erasing unwanted user song.
System memory crashed. Writing data to Flash ROM has failed.
Too many stk/alt.
Displayed when the memory for Stack/Alternate is full and cannot copy the drum kit or add new steps.
Free up space by deleting unwanted Stack/Alternate data, then try again.
USB connection terminated.
A break in the connection with the USB storage device has occurred because of an abnormal electric
current. Disconnect the USB storage device from the USB TO DEVICE connector, then press the
[ENTER/STORE] button.
USB power consumption
exceeded.
The power consumption of the USB storage device connected to the USB TO DEVICE connector
exceeds the regulated value.
USB transmission error. An error has occurred when communicating with the USB storage device.
Utility stored. The settings in the Utility mode have been stored.
LCD Description
Appendix